Velleman K8200 Manual do Utilizador descarregar pdf (Página 27)

If everything went right so far you know that each motor is wired correctly. Now we will test if the extruder works.

Press on the “Heat Extruder” button. Make sure the value in the box is 190°C.

(When you do this you can also see an indicator light on the controller board lighting up, showing that HEATER 1 is

powered).

With the “Heat Extruder” button active, press the “Temperature Curve” tab.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 44 45

Sem comentários

Velleman K8200 Manual do Utilizador Página 27