Velleman MONCOLHA3 Manual do Utilizador descarregar pdf (Página 5)

MONCOLHA3

00 (07/11/2008) 5 Velleman

to the reverse gear power circuit. Make sure there is no power on the

connection wire (remove fuse).Connect the backing-up camera to video

input AV2.

• Apply power to the system (re-insert fuses). The status indication [F]

should light up.

• The sun shade [A] can be removed by sliding it upwards.

7. Use

• Switch on the monitor by pressing the ON/OFF button on the monitor [C]

or remote control [I]. Note that when connection to the reverse gear

system is made, the monitor switches on automatically when reverse

gear is selected.

• Select the video channel (AV1 or AV2) by pressing the video select button

on the monitor [D] or remote control [J].

• Press the mode select button on the monitor [E] or remote control [M] to

select monitor setup presets: STANDARD – SOFT – VIVID – LIGHT.

• Press the menu button [K] on the remote control to enter manual

monitor setup. Use the video select [J] and mode select [M] to navigate

through the settings; use the increase [L] or decrease [N] buttons to

change the settings.

• Brightness, contrast and colour can be set between 0 and 32.

• To select system setup, go to RESET and press the menu button [K]. The

system menu is displayed.

BLUE ON, OFF

Select ON to display a blue screen when no

video signal is detected.

VIDEO AV1, AV2

Select which video input is used for backing up

camera (default: AV2)

BLUEOFF

30S, 1MIN, 3MIN,

5MIN, OFF

Monitor switches off automatically after set

time when no input signal is detected. OFF

disables this function.

• Press on the menu button [K] again to exit the manual monitor setup.

1 2 3 4 5 6 7 8 9 10 ... 21 22

Sem comentários

Velleman MONCOLHA3 Manual do Utilizador Página 5