Velleman HPS40 Manual do Utilizador descarregar pdf (Página 18)

18

©

Velleman

HPS40 Technical Doc

Press RIGHT ARROW KEY,

STEP 10, Input transient

Probe section

Connect the (x10) probe at

scope probe test output.

Adjust the probe

calibration until

pass is indicated.

Press RIGHT ARROW KEY,

STEP 11, Input transient

Scope section

Connect the (x10) probe at

scope probe test output

Adjust CV3 until pass is indi-

cated

Press RIGHT ARROW KEY,

STEP 12, Calibration END

If all steps where correct “Pass”

should be indicated, but due to

possible manipulation Fail,

could be indicated even if all

tests where OK.

PRESS POWER

OFF TO END THE CALIBRATION

1 2 ... 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários