Velleman VM118r Manual do Utilizador descarregar pdf (Página 7)

4) Force the remote/relay card to address 1.

If the receiver (e.g. K8056 or VM118) has been set to an address other than 1..8, you can force it to respond to address 1.

 Attention : All active cards will respond to this command (except when the ‘remote control’ jumper on the relay card is

set to ‘off’). Press ‘shift’ to leave the set-up mode.

Setup

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Sem comentários

Velleman VM118r Manual do Utilizador Página 7