Velleman К8077 Manual do Utilizador descarregar pdf (Página 20)

6. Transformer wiring (red/yellow/blue/grey wires)

Slide an insulation sleeve over each wire.

Solder a connector to each wire

Slide the sleeve over the connector

• Connect the wires to the PCB. Mind the colours!

• Group the wires by means of two cable ties

• Cut the largest of the two heatshrink tubes into 3 pieces: 3cm - 3cm - 4cm

SOLDER

 REMARK : In case you trim the wires, always

remove the insulating lacquer (+/- 1cm)

Mounting power supply section

GREY

RED

BLUE YELLOW

3cm 3cm 4cm

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Sem comentários

Velleman К8077 Manual do Utilizador Página 20