Velleman DVR16H1 User manual Manual do Utilizador descarregar pdf (Página 13)

CONNECTION AND SETUP

For DVR PIN configuration, please refer to “APPENDIX 6 PIN

CONFIGURATION” at page 61. For connection details, please check with your

installer.

STEP 5: Set the speed dome camera at the DVR side.

Go to “ADVANCED CONFIG” l “DEVICES” to set the speed dome camera.

a) Select the device to “PTZ”.

b) Set the ID to the value the same as the one set in the speed dome camera.

The default ID of the camera is 000.

c) Select the protocol to “NORMAL”.

d) Set the baud rate to the value the same as the one set in the speed dome

camera. The default baud rate of the camera is 2400.

ADVANCED CONFIG

CAMERA CH1 CH

CH7 CH

CH1

CH11 W X

DETECTION DEVICE PTZ

ALER

ID 000

NETWORK PROTOCO

NORMA

DISPLA

RATE 2400

RECORD

DEVICES

EXI

2.3 DVR Power On

This device should be operated only with the type of power source indicated on the

manufacturer’s label. Connect the indicated AC power cord to the power adapter, and

plug into an electrical outlet. Then, move the power switch to “\” to power on the DVR.

Note: Before the DVR is powered on, make sure the cameras are connected and

power-supplied for the detection of the camera video system to be correct,

and check the monitor (either LCD or CRT monitor) is connected to the DVR

before the DVR is powered on for correct video output detection.

Note: To ensure that your DVR works constantly and properly, it's recommended

to use an UPS, Uninterruptible Power Supply (Optional), for continuously

operation.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 70 71

Sem comentários

Velleman DVR16H1 User manual Manual do Utilizador Página 13